Connectivity Diagrams


Television, Set Top Box (HDMI or Component)

The below diagram shows the most common connections for your configuration. For each connection type, a colour is used to make the diagram easier to understand. More information on connection types can be found here. Choose your preferred type of connection or quality level from the diagram below, but remember that when using component connection (indicated by the blue colour) you also need to connect an RCA Stereo Cable, or a Digital Coaxial cable, or an Optical cable to your television set or AV receiver to output sound, as component cable does not transmit sound.


Cables

HDMI Cable
Component Cable
SCART Cable
Stereo Cable
RF Cable


Connections

  1. RF cable (aerial), which carries digital and analogue signal to Set Top Box
  2. RF cable, which carries the analogue signal to your television
  3. HDMI cable which allows you to watch your Set Top Box
  4. Component cable which allows you to watch your Set Top Box
  5. RCA Stereo cable which carries the sound of your Set Top Box when you use a Component cable


To Use

  • To watch your Set Top Box using an HDMI cable, select the proper input on your Television by using the input select button on your Television remote (please refer to your Television manual to know which one of your Television's AV input is dedicated to HDMI)
  • To watch your Set Top Box using a Component cable, select the proper input on your Television by using the input select button on your Television remote (please refer to your Television manual to know which one of your Television's AV input is dedicated to Component)


Disclaimer

Devices with SCART may not be available in your area.


I have followed the diagram and it is still not working. What do I do next?

  • Check that your cables are properly inserted. If necessary, disconnect and reconnect them.
  • Check that the cables in the sending device are in the out socket and are connected to the in socket of the receiving device.
  • Make sure that the correct input is selected.
  • Ensure that your cables are not faulty. You can do this by trying with other cables.


<< Back to Index Page 


Back to Top
Last Updated 15th October 2008